Setup - Graco e-Xtreme Operation, Repair, And Parts

Setup

Setup
Setup Setup
To avoid tip over, make sure cart is on a flat and
level surface. Failure to do so could result in injury.
1. Pull pressure adjustment knob (H) out and turn
counterclockwise until it stops. Push the knob
in to lock.
2. Turn power switch (E) OFF. Connect unit to
power source.
10
3. Check packing nut (D). See Xtreme lower pump
manual 311762 for packing nut torque. Fill with
Throat Seal Liquid (TSL
4. Attach electrically conductive fluid hose to pump
lower outlet via outlet check valve and tighten.
NOTICE NOTICE NOTICE
Attaching the hose directly to the lower pump
can result in damage to the sprayer during
cavitation, or when the sprayer runs out of
material. Use an outlet check valve between
the lower pump and hose to avoid damage.
NOTICE
NOTICE NOTICE
The minimum hose size allowable is 3/8 in.
ID x 50 ft (10 mm x 15 m). Smaller hoses
can cause high pressure spikes and result in
damage to the sprayer.
5. Attach hose to gun and tighten.
TM ).
3A3164D