Table of Contents
Advertisement
Problem
I cannot register a handset to a
hub.
Battery recharge
Problem
The handset beeps and/or
blinks.
I fully charged the batteries, but
–
still blinks,
–
is displayed, or
– the operating time seems to
be shorter.
Making/answering calls, intercom
Problem
is displayed.
Noise is heard, sound cuts in
and out.
The handset does not ring.
I cannot make a call.
I cannot make long distance
calls.
For assistance, visit www.panasonic.ca/english/support
HNH100C_(en_en)_0130_ver.202.pdf
Cause/solution
R The maximum number of handsets (6) is already
registered to the hub. Cancel unused handset
registrations from the hub (page 30).
Cause/solution
R Battery charge is low. Fully charge the batteries (page 9).
R Clean the battery ends (
with a dry cloth and charge again.
R It is time to replace the batteries (page 9).
Cause/solution
R The handset is too far from the hub. Move closer.
R The hub's AC adaptor is not properly connected.
Reconnect AC adaptor to the hub.
R The handset is not registered to the hub. Register it
(page 30).
R You are using the handset or hub in an area with high
electrical interference. Re-position the hub and use the
handset away from sources of interference.
R Move closer to the hub.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the hub and the
telephone line jack. Contact your DSL/ADSL provider for
details.
R The ringer volume is turned off. Adjust the ringer volume
(page 14, 26).
R Night mode is turned on. Turn it off (page 28).
R The dialing mode may be set incorrectly. Change the
setting (page 12).
R Make sure that you have long distance service.
47
Useful Information
,
) and the charge contacts
2017/01/30
47
16:12:24
Advertisement
Table of Contents
