Table of Contents
Advertisement
Home Network System Integration
system in time, the sensors are triggered
and the hub and handset sound an alert.
*1
This setting can be changed when using
the Home Network app. For more
information, refer to the User's Guide
(page 42).
Stopping the alert
When a sensor is triggered, the hub and
handset sound an alert. Use the following
procedure to stop the alert.
1
Press MSTOPN or MOFFN.
2
Enter the PIN (default: "0000",
page 40). a MOKN
Note:
R By pressing MDISARMN, you can disarm the
alarm system and stop the alert. See
"Arming and disarming the system",
page 39.
Displaying sensor status
The status of each sensor device is shown on
the handset.
1
MMENUN#801
2
MbN: Select "All locations" or the
area in which the desired sensor devices
belong to. a MSELECTN
3
MbN: Select the desired sensor.
R Press MREFRESHN to refresh the
displayed information.
4
MOFFN
Alert volume
You can adjust the alert volume heard during
At Home mode and Away mode.
– "Alert volume": The volume of the alert
that sounds when the system is not
disarmed within the entry delay time
(page 39).
– "Entry alert volume": The volume of
the alert that sounds during the entry delay
time (page 39).
– "Exit alert volume": The volume of
alert that sounds during exit delay time
(page 39).
For assistance, visit www.panasonic.ca/english/support
40
HNH100C_(en_en)_0130_ver.202.pdf
n Changing alert volume
1
For handset:
MMENUN#803 (At Home) or
MMENUN#804 (Away)
For hub:
MMENUN#*803 (At Home) or
MMENUN#*804 (Away)
2
MbN: Select the desired setting. a
MSAVEN
3
MOFFN
n Changing entry alert volume
1
For handset:
MMENUN#808 (At Home) or
MMENUN#807 (Away)
For hub:
MMENUN#*808 (At Home) or
MMENUN#*807 (Away)
2
MbN: Select the desired setting. a
MSAVEN
3
MOFFN
n Changing exit alert volume
1
For hub:
MMENUN#805 (Away)
2
MbN: Select the desired setting. a
MSAVEN
3
MOFFN
Setting/changing the disarm PIN
You must enter the disarm PIN in order to
disarm the alarm system or stop an alert. The
default PIN is "0000". We recommend
changing the disarm PIN.
Important:
R When you change the disarm PIN, please
make note of the new PIN. The unit will not
reveal the PIN to you. If you forget the PIN,
contact an authorized service center.
1
MMENUN#810
2
Enter the current disarm PIN (4-8 digits).
a MOKN
R Skip this step when setting the disarm
3
Enter the new disarm PIN (4-8 digits). a
MOKN
4
Re-enter the new disarm PIN. a MSAVEN
40
PIN for the first time.
2017/01/30
16:12:24
Advertisement
Table of Contents
