Table of Contents
Advertisement
2
MbN: Select the desired setting. a
MSAVEN
R If you select "Off", press MOFFN to
exit.
3
Enter the desired hour and minute you
wish to start this feature.
4
*: Select "AM" or "PM". a MOKN
5
Enter the desired hour and minute you
wish to end this feature.
6
*: Select "AM" or "PM".
7
MSAVEN a MOFFN
Changing the start and end time
1
MMENUN#237
2
Continue from step 3, "Turning night
mode on/off", page 28.
Selecting groups to bypass night
mode
1
MMENUN#241
2
Select your desired groups by pressing
1 to 9.
R "
" is displayed next to the selected
group numbers.
R To cancel a selected group, press the
same dial key again. "
3
MSAVEN a MOFFN
Call block
This feature rejects calls from unwanted
callers (Caller ID subscribers only). The
following items are available when storing
phone numbers in the call block list (250 max.).
– "Block a single number": The unit
can reject calls from specific phone
numbers.
– "Block range of numbers": The unit
can reject calls that begin with a number
stored in the call block list, such as a
toll-free phone number prefix or certain
area codes.
You can also set the unit to reject calls that do
not have a phone number.
For assistance, visit www.panasonic.ca/english/support
HNH100C_(en_en)_0130_ver.202.pdf
When a call is received, the unit rings briefly
while caller information is being received. If
the caller's phone number matches an entry in
the call block list, the unit emits no sound to
the caller, and disconnects the call.
*1
This is called first ring. If you do not want
the first ring to sound, turn this setting to
"Off" (page 30).
Important:
R Rejected calls are logged in the caller list.
Storing unwanted callers
Storing a single phone number
Important:
R We recommend storing 10 digits (including
the area code). If only 7 digits are stored, all
numbers that have the same last 7 digits
will be blocked.
n From the caller list:
1
MCN CID
2
MbN: Select the entry to be blocked.
R To edit the number: MMENUN a MbN:
" disappears.
3
MMENUN
4
MbN: "Save CID" a MSELECTN
5
MbN: "Call block" a MSELECTN
6
MbN: "Yes" a MSELECTN
7
Edit the phone number if necessary (24
digits max.).
8
MSAVEN a MOFFN
n By entering phone numbers:
1
MMENUN#217
2
MbN: "Block a single number" a
MSELECTN
3
MMENUN a MbN: "Add" a MSELECTN
4
Enter the phone number (24 digits max.).
R To erase a digit, press MCLEARN.
5
MSAVEN a MOFFN
29
Programming
"Edit" a MSELECTN
Press MEDITN repeatedly until the
phone number is shown in the 10-digit
format. And then, press MSAVEN. Go to
step 5.
2017/01/30
*1
29
16:12:23
Advertisement
Table of Contents
