Table of Contents
Advertisement
Useful Information
1
MMENUN#330
R The speakerphone turns on.
2
Follow the pre-recorded instructions.
3
When finished, press MOFFN.
Note:
R You can also use the MVMN soft key, if
displayed, to play new Voice Mail
messages.
Character table
The dial keys are used to enter characters and numbers. Each dial key has multiple characters
assigned to it.
1
2 3
z
*1
The following characters are assigned to the 1 key when entering a Wi-Fi password.
Note:
R While entering characters, you can switch between uppercase and lowercase by pressing *
(A®a).
R To enter another character that is located on the same dial key, first press MEN to move the
cursor to the next space.
R If you do not press any dial key within 2 seconds after entering a character, the character is
fixed and the cursor moves to the next space.
R
in the above table represents a single space.
Erasing the character or number
To erase a character or number, press MFN or MEN and then press MCLEARN.
To erase all characters and numbers, press and hold MCLEARN.
Error messages
Display message
Access # to VM
service is not
stored
For assistance, visit www.panasonic.ca/english/support
44
HNH100C_(en_en)_0130_ver.202.pdf
R If the handset still indicates there are new
messages even after you have listened to
all new messages, turn it off by pressing
and holding # until the handset beeps.
4
5 6
Cause/solution
R You have not stored the Voice Mail access number. Store the
number (page 43).
44
7
8
9
y
2017/01/30
16:12:24
Advertisement
Table of Contents
