Power State At Cold Start Set - Planar VM55LX-X User Manual

Vm series displays
Hide thumbs Also See for VM55LX-X:
Table of Contents

Advertisement

10.3 Power State at Cold Start Set

Bytes
Bytes Description
0xA3 = Power State at Cold
DATA[0]
Start- Set
DATA[1]
Power State at Cold Start
The value is stored and applied only when the display starts up from cold start power state the
next time:
Power Off: The monitor will automatically switch to Power Off mode (even if the last
status was on) whenever the main power turns on, or resumes after a power interruption.
Forced On: The monitor will automatically switch to Power On mode whenever the main
power turns on or resumes after a power interruption.
Last Status: The monitor will be automatically switch to the last status (either Power Off
or On) whenever the main power turns on or resumes after a power interruption.
Example: Report status of Forced On for Power State at Cold Start (Display Address 01)
Header
Monitor ID
0x21
0x01
VM Series Displays RS232 User Guide
020-1359-00A
Category
Page
Length
0x00
0x00
0x04
Bits
Description
Set Power State at Cold Start
0x00 = Power Off
0x01 = Forced On
0x02 = Last Status
Data Control
Data[0]
0x01
0xA4
General
Data[1]
Checksum
0x01
0x80
Page | 17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vm55mx-xVm55lx-u

Table of Contents