Tiling; Tiling Get; Tiling Report - Planar VM55LX-X User Manual

20. Tiling

Use this command to set/get the tiling status as outlined below.

20.1 Tiling Get

Bytes Bytes Description
DATA[0] 0x23 = Tiling- Get
Example: (Display Address 01)
Header Monitor ID
0xA6 0x01

20.2 Tiling Report

Bytes Bytes Description
DATA[0] 0x23 = Tiling- Report
DATA[1] Enable
DATA[2] Frame comp.
DATA[3] Position
DATA[4] V monitors, H monitors
Note 1:
1. The maximum Position value is 225 (hexadecimal value is 0xE1).
2. The Position is counted from left to right, then up to down in the Tiling Wall.
Example: See Figure 1 for the hexadecimal Position value in a 4x3 (H Monitors x V Monitors) Tiling Wall.
Example: See Figure 2 for the hexadecimal Position value in a 5x5 (H Monitors x V Monitors) Tiling Wall.
Example: See Figure 3 for the hexadecimal Position value in a 15x10 (H Monitors x V Monitors) Tiling
Wall
Note 2:
1. The maximum H Monitors are 15 and the maximum V Monitors are 15.
Data [4] = (V Monitors – 1) x 15 + H Monitors
Example: If H Monitors = 12 and V Monitors = 6, the Data [4] value will be (6–1) x 15 + 12 = 87
See Figure 3 for the hexadecimal Position value in a 4x3 (H Monitors x V Monitors) Tiling Wall.
VM Series Displays RS232 User Guide
020-1359-00A
Bits
Category Code0 Code1
0x00 0x00 0x00
Bits
Description
Command requests the display to report
Tiling status.
Data
Length
Control
0x03 0x01
Description
Command reports Tiling Setting
0x00 = No
0x01 = Yes
0x00 = No
0x01 = Yes
0x01 = position 1
0x02 = position 2
till
See Note 1
0x00 = don't care
0x01 = V monitors =1 H monitors =1
0x02 = V monitors =1 H
monitors =2 till
See Note 2
Miscellaneous
Data[0] Checksum
0x23 0x86
Page | 33