Remote Connection Through The Bmc - Nvidia DGX-2 SYSTEM User Manual

REMOTE CONNECTION THROUGH THE BMC

See the section Configuring Static IP Address for the BMC
static IP address for the BMC.
This method requires that you have the BMC login credentials. These credentials
depend on the following conditions:
Prior to first time boot: The default credentials are
Username: admin
Password: admin
After first boot setup: The administrative user username that was set up during the
initial boot is used for both the BMC username and BMC password.
Username: <administrator-username>
Password: <administrator-username>
After first boot setup with changed password: The BMC password can be changed
from "<system-username>", in which case the credentials are
Username: <administrator-username>
Password: <new-bmc-password>
Make sure you have connected the BMC port on the DGX-2 System to your LAN.
1.
Open a browser within your LAN and go to:
2.
https://<ipmi-ip-address>/
Make sure popups are allowed for the BMC address.
Log in.
3.
DGX-2 System User Guide
Connecting to the DGX-2 Console
if you need to configure a
17