Emergency Stop Switch; Lanyard Stop Switch - Mercury TDI 3.0L Owner's Operation And Maintenance Manual

Section 1 - Getting to Know Your Power Package
Bilge Blower Toggle Switch
ON
OFF
38277

Emergency Stop Switch

An emergency stop (E‑stop) switch is used to turn off the engines in an emergency situation, such as a person overboard or a
tangled propeller. When activated, an E‑stop switch interrupts the power supply to the engine and transmission. If the boat is
equipped with an E‑stop switch, the E‑stop switch turns off all of the engines.
Activation of an E‑stop switch stops the engine, or engines, immediately, but the boat can continue to coast for some distance
depending upon the velocity and degree of any turn at shutdown. While the boat is coasting, it can cause injury to anyone in the
boat's path as seriously as the boat would when under power.
We recommend instructing other occupants on proper starting and operating procedures should they need to operate the
engine in an emergency.
Accidental or unintended activation of the switch during normal operation is also possible, which can cause any or all of the
following potentially hazardous situations:
• Occupants can be thrown forward due to unexpected loss of forward motion, and passengers in the front of the boat could
be ejected over the bow and possibly struck by the propulsion or steering components.
• The operator can lose power and directional control in heavy seas, strong current, or high winds.
• The operator can lose control of the vessel when docking.
Restarting an engine using the key switch or start button after an E‑stop shutdown without first turning the key switch to the off
position for at least 30 seconds will restart the engine but cause fault codes to be set. Unless you are in a potentially hazardous
situation, turn the key switch off and wait at least 30 seconds before restarting the engine or engines. If after restarting, some
fault codes are still being displayed, contact your authorized Mercury Diesel repair facility.

Lanyard Stop Switch

The purpose of a lanyard stop switch is to turn off the engine when the operator moves far enough away from the operator's
position (as in accidental ejection from the operator's position) to activate the switch. Tiller handle outboards and some remote
control units are equipped with a lanyard stop switch. A lanyard stop switch can be installed as an accessory ‑ generally on the
dashboard or side adjacent to the operator's position.
A decal near the lanyard stop switch is a visual reminder for the operator to attach the lanyard to their personal flotation device
(PFD) or wrist.
Page 10
Operates the bilge blower, if equipped.
Typical E-stop switch
35308
90-8M0145546 MAY 2018
eng