Dell PowerEdgeFC430 Owner's Manual page 94

NOTE: You must remove the SSD cage to replace a faulty SSD cage or service other components inside the system.
1 Followthesafetyguidelineslistedinthe Safetyinstructions section.
2 FollowtheprocedurelistedintheBefore workinginside yoursystemsection.
3 Keep the Phillips #1 screwdriver ready.
Steps
1 Align the slots onthe sides of the SSD cage withthe guide pins on the chassis.
2 Push the SSD cage into the chassis until the screwholes on the chassis are aligned withtheholesonthe SSDcage.
3 Slide the SSD cage into thechassis till the IDSDM card connector engages completely withthe connector onthesystem board.
4 Secure the SSD cage to the chassis with the screws.
Figure 39. Installing the SSD cage
1 chassis
3 SSD cage
5 guide pin (4)
Next steps
1 Install the SSD backplane.
2 Install the SSDs.
3 Followthe procedure listed inthe After working inside your systemsection.
Related links
Safety instructions
Before working inside your system
Installing the SSD backplane
Installing an SSD carrier
After working inside your system
Removing the SSD cage
94 Installing and removing sled components
2 guide pin slot (4)
4 screw (4)