Dell PowerEdgeFC430 Owner's Manual page 38

Table of Contents

Advertisement

Option
Description
Embedded SATA
Enables the embedded SATA option to be set to Off, ATA, AHCI, or RAID modes. This option is set to AHCI by
default.
Security Freeze
Sends Security Freeze Lock command to the Embedded SATA drives during POST. This option is applicable only
Lock
for ATA and AHCI modes.
Write Cache
Enables or disables the command for Embedded SATA drives during POST.
Port A
Sets the drive type of theselected device. For Embedded SATA settings in ATA mode, set this field to Auto to
enable BIOS support. Set it to OFF to turn off BIOS support.
For AHCI or RAID mode, BIOS support is always enabled.
Option
Model
Drive Type
Capacity
Port B
Sets the drive type of theselected device. For Embedded SATA settings in ATA mode, set this field to Auto to
enable BIOS support. Set it to OFF to turn off BIOS support.
For AHCI or RAID mode, BIOS support is always enabled.
Option
Model
Drive Type
Capacity
Related links
SATA Settings
Viewing SATA Settings
Integrated Devices
You can use the IntegratedDevicesscreen to viewand configure the settings of all integrated devices including the video controller,
integratedRAIDcontroller,andtheUSBports.
Related links
Integrated Devices details
System BIOS
Viewing Integrated Devices
Viewing Integrated Devices
To view the Integrated Devices screen, perform the following steps:
1
Turn on, or restart your system.
2
Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then restart
yoursystemandtryagain.
38
Pre-operating system managementapplications
Description
Specifies the drive model of the selected device.
Specifies the type of drive attached to the SATA port.
Specifies the total capacityof the hard drive. This field is undefined for removable media
devices such as optical drives.
Description
Specifies the drive model of the selected device.
Specifies the type of drive attached to the SATA port.
Specifies the total capacityof the hard drive. This field is undefined for removable media
devices such as optical drives.

Advertisement

Table of Contents
loading

Table of Contents