Dell PowerEdgeFC430 Owner's Manual page 102

CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
CAUTION: Take care not to damage the system identification button while placing the system board into the chassis.
Steps
1 Align the system board withthe standoffs on the chassis.
2 Secure the system board to the chassis withthe screws.
Figure 46. Installing the system board
1 system board holder
Next steps
1 Install the Trusted Platform Module (TPM). For information about how to install TPM, see the Installing the trusted platform modules
section. For information about TPM, see theTrusted Platform Module section.
2 Install the following components:
• LOMrisercard
• PCIe mezzanine card
• SSD cage
• SSD backplane
• SSDcarriers
NOTE: Ensure that you reinstall the SSD carriers into their original bays.
• Coolingshroud
• Memory modules
• Processor(s) and heat sink(s)
3 Followthe procedure listed inthe After working inside your systemsection.
NOTE: If you are not installing the sled in the enclosure, install the I/O connector cover.
Import your new or existing iDRAC Enterprise license. See the iDRAC8 User's Guide at Dell.com/idracmanuals.
4
5 Ensure that you:
a Use the Easy Restore feature torestore the Service Tag. For more information, see the Restoring the Service Tag using Easy
Restore section.
b If the Service Tag is not backed up in the backup flash device, enter the system Service Tag manually. For more information,
seetheEnteringthesystemServiceTagsection.
c Update the BIOS and iDRAC versions.
d Re-enable the Trusted Platform Module (TPM). For more information, see the Re-enabling the TPM for BitLocker users or Re-
enabling the TPM for Intel TXTusers section.
102 Installing and removing sled components
2 system board