Printing A Demo Page; Changing The Display Language; Using Toner Save Mode - Samsung ML-3470 User Manual

Item
You can set the number of lines printed in one vertical
LPI
inch.
This item determines whether or not the printer
Auto
automatically performs line feed when the data
Wrap
overflows the printable area of the print material.
Network menu(ML-3471ND only)
This menu lets you configure the network interface installed in your
printer. You can reset the network interface and print a configuration
page.
Item
This item allows you to manually set the TCP/IP
TCP/IP
addresses or receive the addresses from the
network.
• DHCP: The DHCP server allots the IP address to
you automatically.
• BOOTP: The BOOTP server allots the IP address
to you automatically.
• Static: You can enter IP address, subnet mask,
and gateway manually.
This item lets you select whether or not you use the
EtherTalk
EtherTalk protocol. Select On to use the protocol.
This item allows you to select the ethernet speed.
Ethernet
Speed
Configure the wireless network environments.
Wireless
See page 10.3.
Note
This menu only appears when an optional
wireless network interface card has been
installed.
This item performs a simple reset and restores the
Clear
factory default settings for the network
Setting
configuration. This setting will only take effect after
you have reset the printer.
This item print a page showing the network
Network
parameters you set.
Info.
Explanation
Explanation

Printing a demo page

Print a demo page to make sure that the printer is operating correctly.
Press Menu and then OK when Information appears.
1
Press the scroll buttons until Demo Page appears and press OK.
2
A demo page prints out.

Changing the display language

To change the language that is displayed on the control panel, follow
these steps:
Press Menu until System Setup appears on the bottom line of the
1
display and press OK.
Press OK when Language appears.
2
Press the scroll buttons to select the language you want and press
3
OK.
Press Stop to return to Standby mode.
4

Using toner save mode

Toner save mode allows the printer to use less toner on each page.
Activating this mode extends the life of your toner cartridge and reduces
your cost per page beyond what one would experience in the normal
mode, but it reduces print quality.
There are two ways to enable this mode:
Using the control panel button
Press Toner Save on the control panel. The printer must be in Standby
mode; the Status LED lights green and
• If the button backlight is on, the mode is enabled and the printer uses
less toner to print a page.
• If the button backlight is off, the mode is disabled and the printer prints
in normal mode.
From the software application
You can set toner save mode from the printer properties window on your
printer driver. See the Software Section.
2.5
<System setup>
is shown on the display.
Ready