Charger 2 Damper Installation - SRAM RockShox RS-1 Service Manual

2 0 0 H o u r S e r v i c e
Install the Charger 2 Damper into carbon fiber upper until the lockout
1
extension shaft protrudes from the hole in the knob base.
Insert the anchor tool into the carbon fiber upper.
2
Make sure the wiper seal slides onto the tool without folding the outer lip of
the seal.
Tighten the anchor counter-clockwise. Remove the anchor tool from the
carbon fiber upper.
For easier installation, apply a thin layer of grease to the inside lip of the
anchor tool.
Clean the inside and outside of the stanchion
3
Slide the stanchion into the carbon fiber upper until it stops and the shaft is
4
visible through the bottom bolt hole.
C h a r g e r 2 D a m p e r ™ I n s t a l l a t i o n
NOTI CE
Anchor tool
Charger 2 Damper™ Installation
30 mm 12 N·m (110 in-lb)
35