Rebound Damper Installation - SRAM RockShox SEKTOR Service Manual

2 0 0 H o u r S e r v i c e
Insert the rebound damper piston and seal head into the upper tube.
1
Push the seal head into the upper tube until the retaining ring groove
is visible.
Push the rebound damper into the upper tube and thread a bottom bolt
2
into the shaft.
Retaining rings have a sharper edged side and a rounder edged side.
3
Installing retaining rings with the sharper edged side facing the tool
will allow for easier installation and removal.
Install the retaining ring into the upper tube groove.
Do not scratch the rebound damper shaft. Scratches will allow oil to
leak into the lower leg, resulting in reduced damping performance.
Confirm the retaining ring is properly seated in the retaining ring
groove by using the retaining ring pliers to rotate the retaining ring
and seal head back and forth a few times.
R e b o u n d D a m p e r I n s t a l l a t i o n
NOTI CE
⚠ CAU TI ON
Retaining ring pliers

Rebound Damper Installation

37