Air Spring Installation - SRAM RockShox RS-1 Service Manual

2 0 0 H o u r S e r v i c e
Apply a liberal amount of grease to the inside of the stanchion, from the
1
unthreaded end of the tube to approximately 60 mm into the tube.
Apply a liberal amount of grease to the air piston and around the air shaft.
2
Install the floating seal head, floating seal head top out bumper, aluminum
3
support washer, wavy washer, and air shaft guide, in that order, onto the
air shaft.
Push the air shaft and seal head assembly into the unthreaded end of the
4
stanchion.
Orient the washers so that the aluminum support washer goes into the
upper tube first, followed by the wavy washer.
Use your fingers to firmly press the air shaft guide into the stanchion until it
snaps into place.
A i r S p r i n g I n s t a l l a t i o n
Seal head assembly orientation

Air Spring Installation

18