Connecting The Video Cable - Samsung DVD-VR300 Instruction Manual

Method 3 : Antenna + DVD
Recorder-VCR + Cable box +TV :
Cable box with a few scrambled
channels
You can record non-scrambled channels by selecting the
channel on the cable box. You cannot record scrambled
channels that require a cable box.
Wall
To RF OUT
IN
Cable box
TV
ANT
To ANT INPUT
Step 3: Connecting the
Video Cable
There are several ways to connect your DVD Recorder-VCR.
Select one of the following video connecting methods that
best suits you below.
• Method 1 : Connecting to a Video input jack
• Method 2 : Connecting to an S-video input jack
• Method 3 : Connecting to Component video input jacks in
480i mode
• Method 4 : Connecting to Component video input jacks in
480p mode
S-Video, Component video and Progressive Output
Modes
• S-Video and Component video output are available only if
your TV supports S-Video input or Component video
input, respectively. If S-Video or Component video output
does not work, check the TV connections and the TV
input selection settings.
16 - English
IN
COMPONENT (FROM ANT.)
AUDIO OUT VIDEO OUT
LINE OUT LINE IN 1
R Y R R R R
AUDIO AUDIO
RF RF
L C /P B B L L L L
DIGITAL AUDIO OUT
C R /P R
OUT
(TO TV)
OPTICAL COAXIAL VIDEO VIDEO
IN
(FROM ANT.)
To RF IN
RF RF
OUT OUT
(TO TV)
OUT
RF Cable
• Compared to standard interlaced video, progressive scan
doubles the amount of video beam lines fed to your TV ,
resulting in a more stable, flicker-free, and clear image than
interlaced video. The progressive scan video output jack is
used in progressive output mode. This is only available
with TVs that support progressive scan.
• Consumers should note that not all high definition televi-
sion sets are fully compatible with this product and may
cause artifacts to be displayed in the picture. If you experi-
ence 525 progressive scan picture problems, it is recom-
mended that you switch the connection to the 'standard
definition' output. If there are questions regarding TV set
compatibility with this unit, please contact our customer
service center at 1-800-SAMSUNG.
Method 1 : Connecting to a video
input jack
Connect a video(yellow) cable between the VIDEO (yellow)
OUT jack on DVD Recorder-VCR and VIDEO(yellow) IN
jack on the TV(or AV amplifier).
• You will enjoy regular quality images.
• Connect audio cables (white and red) between the ANA-
LOG AUDIO OUT jack on the DVD Recorder-VCR and
AUDIO IN jack on TV (or AV amplifier).
IN
(FROM ANT.)
COMPONENT
VIDEO OUT
AUDIO OUT
LINE OUT LINE IN 1
R Y R R R R
AUDIO AUDIO
RF RF
L C B /P B L L L L
DIGITAL AUDIO OUT
C /P R R OUT
OPTICAL COAXIAL (TO TV)
VIDEO VIDEO
LINE OUT
R
AUDIO
L L
VIDEO
INPUT
L
AUDIO AUDIO
R