Table of Contents
Advertisement
Connecting the
HDD & DVD RECORDER
1. Disconnect the aerial cable from your TV and
connect it to ANT IN connector on the rear panel of
the HDD & DVD RECORDER.
2. Connect ANT OUT (TO TV) connector of the HDD &
DVD RECORDER and the aerial input of your TV
using the supplied aerial cable.
3. Use the Video/Audio Cable to connect ANALOG
AUDIO OUT(R/L)/VIDEO OUT jacks on the HDD &
DVD RECORDER to the Audio &Video jacks on the
TV.
4. Plug in the HDD & DVD RECORDER and TV
5. Turn on the HDD & DVD RECORDER and TV.
6. Press the INPUT button on your TV remote control
until the Video signal from the HDD & DVD
RECORDER appears on the TV screen.
Wall
Wall
or
or
or
or
The RF cable connection of this product
sends only signals of TV. You must connect
NOTE
Audio/Video cables to watch a DVD form your
HDD & DVD RECORDER.
Power off HDD & DVD RECORDER, then you
can watch programmes received through 2 RF
cable.
Other type of connecting
the Video output cable
There are several ways to output video signal.
Select one of the following video connecting that best suits
you below.
• Case 1 : Connecting to a Video (Composite) output jack
• Case 2 : Connecting to an S-Video output jack
• Case 3 : Component Video output jacks
S-Video, Component video and Progressive Output Modes
• S-Video and Component video output are available only if
your TV supports S-Video input or Component video
input, respectively. If S-Video or Component video output
does not work, check the TV connections and the TV
input selection settings.
• Compared to standard interlaced video, progressive scan
doubles the amount of video lines fed to your TV,
resulting in a more stable, flicker-free, clear image than
interlaced video. This is only available with TVs that
support progressive scan.
• Progressive Scan Output (576p)
Consumers should note that not all high definition
television sets are fully compatible with this product and
may cause artifacts to be displayed in the picture, in case
of 576 progressive scan picture problems, It is
recommended that the user switch the connection to the
'standard definition' output. If there are questions
regarding our TV set compatibility with this model 576p
HDD & DVD RECORDER, please contact our customer
service centre.
Case 1 : Connecting to a Video
(Composite) output jack
1. Connect a video(yellow) cable between the VIDEO
(yellow) OUT jack on HDD & DVD RECORDER and
VIDEO (yellow) INPUT jack on your TV (or AV amplifier).
• You will enjoy regular quality images.
2. Connect audio cables (white and red) between the
AUDIO OUT jacks on the HDD & DVD RECORDER and
AUDIO IN jacks on TV (or AV amplifier).
(See pages 21)
yellow
yellow
English - 19
Advertisement
Table of Contents
