Setting Procedures For Axes Groups; Setting Procedure For An Axes Group; Setting Procedure - Omron NJ501-1400 User Manual

3 Configuring Axes and Axes Groups
3-4

Setting Procedures for Axes Groups

This section gives the procedures to use the Sysmac Studio to set up an axes group. No configuration
is required if you are not going to use any axes group command instructions, such as linear interpola-
tion or circular interpolation.
3-4-1

Setting Procedure for an Axes Group

START
Start the Sysmac Studio.
Add an axes group.
Set the axes group parameters.
Go online and synchronize the data.
Transfer the project to the Controller.
END
3-4-2

Setting Procedure

This section gives the procedures to use the Sysmac Studio to set up an axes group in a project that
already contains the axes.
Starting the Sysmac Studio
1
Start the Sysmac Studio and open the project.
3-22 NJ-series CPU Unit Motion Control User's Manual (W507)