Axis Setting Procedure; Axis Configuration Procedure; Setting Procedure - Omron NJ501-1400 User Manual

3 Configuring Axes and Axes Groups
3-2

Axis Setting Procedure

This section gives the procedures to set servo axes that are newly created with the Sysmac Studio.
3-2-1

Axis Configuration Procedure

3-2-2

Setting Procedure

This section describes how to set an axis.
Starting the Sysmac Studio
1
Start the Sysmac Studio and click the New Project Button.
2
Set the project properties and click the Create Button.
A new project is displayed.
3-8
START
Create a project.
Create the EtherCAT Network Configuration.
Add axes.
Assign the axes.
Set the axis parameters.
Go online and synchronize the data.
Transfer the project to the Controller.
END
NJ-series CPU Unit Motion Control User's Manual (W507)