Table of Contents
Advertisement
INSTALLATION
CHEMICAL
CONNECTIONS
Chemical connections
should be made by the
chemical supplier.
Using deionized water or
other aggressive fluids
will result in corrosion and
failure of components and
will void the warranty.
!
WARNING
WARNING! Some of the
chemicals used in
dishwashing may cause
chemical burns if they
come in contact with skin.
Wear protective gear when
handling these chemicals.
If any skin comes in
contact with these
chemicals, immediately
follow the instructions
provided with the
chemicals for treatment.
PLUMBING CHECK
07610-002-23-32-AD
Connect detergent by removing the bulkhead fitting on the back of the machine and
replacing it with the appropriate dispensing equipment.
Connect rinse-aid by removing one of the brass plugs at the base of the rinse injector
and replacing it with the appropriate dispensing equipment.
See "Plumbing - HH-E-VER" page for a depiction of the VER rinse injector.
The electrical connections for chemical dispensers are made on a fuse block inside
here
the control box. Click
Slowly turn on the water supply to the machine after the incoming fill line and drain
line have been installed. Check for any leaks and repair as required. All leaks must be
repaired before operating the machine.
Detergent
Detergent Probe
Installs Here
Rinse-aid
Dispenser Electrical Connections
for a depiction of the fuse block and connection locations.
INSTRUCTIONS
Rinse-aid
10
Advertisement
Table of Contents
