Chemical Feeder Equipment; Preparing Chemical Feeder Pumps; Priming Chemical Feeder Pumps - Jackson DISHSTAR Series Installation, Operation And Service Manual

INSTALLATION
CHEMICAL FEEDER
EQUIPMENT
PREPARING
CHEMICAL FEEDER
PUMPS
PRIMING CHEMICAL
FEEDER PUMPS
!
WARNING
WARNING! Some of the
chemicals used in
dishwashing might cause
chemical burns if they
come in contact with skin.
Wear protective gear when
handling these chemicals.
If any contact with skin
occurs, immediately
follow the treatment
instructions provided
with the chemicals.
07610-004-37-13-R
CAUTION! Chlorine-based sanitizers can be detrimental to this machine
!
if the chemical solution is too strong. See a chemical professional to
ensure the dispenser is set-up correctly.
CAUTION
The bottom of the chemical container cannot be located any higher than 8" from the
floor. If the unit is equipped with the 6" or 18" table stand, the highest position will be
14" or 26" from the floor, respectively. It is important to remember that if you decide
to operate the unit in chemical-sanitizing mode, you must ensure an appropriate
chlorine-based sanitizer is used in the final rinse line.
The DishStar HT dishmachine is supplied with detergent and rinse-aid chemical
feeder pumps.
The DishStar LT and LT-H dishmachines are supplied with detergent, rinse-aid, and
sanitizer chemical feeder pumps.
Locate the open ends of the chemical tubes with the tube stiffeners and place each
one in the appropriate container.
• Red Tubing = Detergent
• White Tubing = Sanitizer
Chemical feeder pumps need priming when the machine is first installed or if the
chemical lines have been removed and air was allowed to enter.
!
CAUTION! Water must be in the sump and wash tank before chemicals
are dispensed.
CAUTION
HT
1. Press and hold prime button toward DETERGENT PRIME until display shows
timer. Priming cycle defaults to 70 seconds. Observe wash tank during priming
cycle. If too much detergent, press prime button to stop priming cycle. If not
enough, run priming cycle again.
70
2. Press and hold prime button toward RINSE AID PRIME until display shows
timer. Priming cycle defaults to 180 seconds.
180
INSTRUCTIONS
• Blue Tubing = Rinse-Aid
8