Table of Contents
Advertisement
TROUBLESHOOTING
!
WARNING
PROBLEM
Machine doesn't
drain when power
switch is flipped to
"OFF."
Incorrect water
pressure displayed
during Fill or Rinse
modes.
Wash water is not
reaching required
temperature.
Door will not close
completely.
Water leaks at the
wash pump.
Will not rinse during
autocycle.
Dishes are not
coming clean.
07610-002-23-32-AD
WARNING! Inspection, testing, and repair of electrical equipment should only be performed by a
qualified service technician. Many of the tests require that the unit have power to it and live electrical
components be exposed. USE EXTREME CAUTION WHEN TESTING THE MACHINE.
POSSIBLE CAUSE
1. Drain clogged.
2. Standpipe not removed before
draining.
1. Water turned off.
1. Faulty wash heater.
2. Misadjusted/faulty thermostat(s).
3. Wash thermometer is defective.
1. Improper spring tension.
2. Obstruction in door channel.
3. Door panels are not square with
frame.
1. Wash pump seal defective.
2. Petcock or pump drain (if
equipped) not shut/tight.
3. Loose hoses (hose clamps) on
the wash pump.
1. Defective rinse solenoid.
2. Faulty timer.
3. No water to the machine.
1. Machine temperatures are not up
to the minimum requirements.
2. No detergent/too much
detergent.
COMMON PROBLEMS
REMEDY
1. Remove obstruction.
2. Remove standpipe and run drain cycle again.
1. Turn water on.
1. Check element for continuity; if open, replace the heater.
2. Verify operation and setting of thermostats, replace if
necessary.
3. Replace thermometer.
1. Adjust spring tension as required by loosening (not
removing) spring bolt nuts and adjusting the tension.
Tighten nuts back when done.
2. Remove the obstruction.
3. Adjust the frame to accommodate the door panels.
1. Replace the seal.
2. Close or tighten.
3. Tighten the hose clamps.
1. Repair or replace the rinse solenoid as required.
2. Replace timer.
3. Verify there is water at 10 ± 2 PSI connected to the
machine.
1. Verify incoming water, rinse water, and wash water
match the required temperatures as listed on the
machine data plate.
2. Adjust detergent concentration as required for the
amount of water held by the machine.
21
Advertisement
Table of Contents
