Adjusting The Pre-Tension Assembly Position (Premier Specifications) - Brother S-7300A Service Manual

7-10-5.

Adjusting the pre-tension assembly position (Premier specifications)

Thread trimmer solenoid ON position
11mm
Touching
0.05 - 0.1mm
1. Tighten the tension nut (1) so that it is 11 mm from the
end of the screw (2).
2. Loosen the set screw (3).
3. Set the thread trimmer solenoid (4) to the ON position,
and then adjust the position of the pre-tension assembly
(7) so that the clearance between the tension release
plate (5) and tension release bar A (6) is 0.05 to 0.1 mm.
4. Tighten the set screw (3).
1020D
1021D
S-7300A
7. ADJUSTMENTS
136