Table of Contents
Advertisement
2.
Configure the settings in "Application Setting" as follows.
[Navigation window] [Parameter] [Module Information] [R60TCTRT2TT2] [Module Parameter] [Application
Setting]
• "Control basic parameters"
Set "Target Value(SV) Setting" of CH1 and CH2, and "Unused channel setting" of CH3 and CH4 as shown below.
• "Limiter setting"
Set "Upper Limit Setting Limiter" of CH1 and CH2 as shown below.
• "Simultaneous temperature rise setting"
Set "Simultaneous temperature rise group setting" and "Simultaneous temperature rise AT mode setting" of CH1 and CH2 as
shown below.
• "Alert setting"
Set "Alert 1 mode setting" and "Alert set value 1" of CH1 and CH2 as shown below.
• "Auto tuning setting"
Set "Automatic backup setting after auto tuning of PID constants" of CH1 and CH2 as shown below.
Use the default values for the parameters other than the parameters shown above.
7 OPERATION EXAMPLES
60
7.2 Program Examples
Advertisement
Table of Contents
