Table of Contents
Advertisement
2.
Configure the settings in "Application Setting" as follows.
[Navigation window] [Parameter] [Module Information] [R60TCTRT2TT2] [Module Parameter] [Application
Setting]
• "Control basic parameters"
Set "Target Value(SV) Setting" of CH1 and "Unused channel setting" of CH2 to CH4 as shown below.
• "Limiter setting"
Set "Upper Limit Setting Limiter" of CH1 as shown below.
• "Alert setting"
Set "Alert 1 mode setting" and "Alert set value 1" of CH1 as shown below.
• "Auto tuning setting"
Set "Automatic backup setting after auto tuning of PID constants" of CH1 as shown below.
Use the default values for the parameters other than the parameters shown above.
■Writing to the CPU module
1.
Write the set parameters to the CPU module, reset the CPU module, and turn off and on the power supply.
[Online] [Write to PLC]
7 OPERATION EXAMPLES
54
7.2 Program Examples
Advertisement
Table of Contents
