Cable And Port Specifications; Cables And Adapters - Cisco MDS 9148T Hardware Installation Manual

Cable and Port Specifications

This appendix includes information about the cables and connectors used with the Cisco MDS 9148T Multilayer
Fabric Switch.
Caution
We strongly recommend that power cable runs and other potential noise sources be located as far away as
practical from network cabling that terminates at Cisco equipment. In situations where long parallel cable
runs exist, but cannot be separated by at least 3.3 ft. (1 m), we recommend that you shield these potential
noise sources. To avoid interference, the source should be shielded by housing it in a grounded metallic
conduit.
•
•
•
•

Cables and Adapters

The Cisco MDS 9148T Switch accessory kit includes the following:
• RJ-45-to-RJ-45 rollover cable
• RJ-45-to-DB-9 female DTE adapter (labeled Terminal)
• RJ-45-to-DB-25 female DTE adapter (labeled Terminal)
• RJ-45-to-DB-25 male DCE adapter (labeled Modem)
Note
Additional cables and adapters can be ordered from your customer service representative.
Note
If you purchased this product through a Cisco reseller, contact the reseller directly for technical support. If
you purchased this product directly from Cisco, contact Cisco Technical Support at
http://www.cisco.com/c/en/us/support/index.html.
Cables and Adapters, on page 55
Console Port, on page 56
Out of Band Ethernet Management Port, on page 57
Supported Power Cords and Plugs, on page 59
Cisco MDS 9148T 32-Gbps 48-Port Fibre Channel Switch Hardware Installation Guide
A
A P P E N D I X
55