Table of Contents
Advertisement
Cable and Port Specifications
This appendix includes the cables and connectors used with the Cisco MDS 9396S Multilayer Fabric Switch.
We strongly recommend that power cable runs and other potential noise sources be located as far away
Caution
as practical from network cabling that terminates on Cisco equipment. In situations where long parallel
cable runs exist but cannot be separated by at least 3.3 ft. (1 m), we recommend that you shield these
potential noise sources. To avoid interference, the source should be shielded by housing it in a grounded
metallic conduit.
•
•
•
•
Cables and Adapters
The Cisco MDS 9396S Switch accessory kit includes the following:
• RJ-45 to RJ-45 rollover cable
• RJ-45 to DB-9 female DTE adapter (labeled "Terminal")
• RJ-45 to DB-25 female DTE adapter (labeled "Terminal")
• RJ-45 to DB-25 male DCE adapter (labeled "Modem")
Note
Additional cables and adapters can be ordered from your customer service representative.
Cables and Adapters, page 61
Console Port, page 62
MGMT 10/100/1000 Ethernet Port, page 64
Supported Power Cords and Plugs, page 66
A P P E N D I X
Cisco MDS 9396S Multilayer Fabric Switch Hardware Installation Guide
A
61
Advertisement
Table of Contents
