Appendix A Cable And Port Specifications; Cables And Adapters - Cisco MDS 9396T Hardware Installation Manual

Cable and Port Specifications
This appendix includes the cables and connectors used with the Cisco MDS 9396T Multilayer Fabric Switch.
Caution We strongly recommend that power cable runs and other potential noise sources be located as far away as
practical from network cabling that terminates on Cisco equipment. In situations where long parallel cable
runs exist but cannot be separated by at least 3.3 ft. (1 m), we recommend that you shield these potential noise
sources. To avoid interference, the source should be shielded by housing it in a grounded metallic conduit.
•
•
•
•

Cables and Adapters

The Cisco MDS 9396T Switch accessory kit includes the following:
• RJ-45 to RJ-45 rollover cable
• RJ-45 to DB-9 female DTE adapter (labeled "Terminal")
• RJ-45 to DB-25 female DTE adapter (labeled "Terminal")
• RJ-45 to DB-25 male DCE adapter (labeled "Modem")
Note Additional cables and adapters can be ordered from your customer service representative.
Note
If you purchased this product through a Cisco reseller, contact the reseller directly for technical support. If
you purchased this product directly from Cisco, contact Cisco Technical Support at this URL:
http://www.cisco.com/c/en/us/support/index.html.
Cables and Adapters, on page 53
Console Port, on page 54
MGMT 10/100/1000 Ethernet Port, on page 55
Supported Power Cords and Plugs, on page 57
A P P E N D I X
Cisco MDS 9396T Multilayer Fabric Switch Hardware Installation Guide
A
53