Table of Contents
Advertisement
Hardwire Conduit Option
1
Remove any loose items in the dishwasher and carefully
Remove bottom pan. Note: Rapid removal of the bottom pan will
lay the dishwasher on its back. Note: Be careful not to
cause damage to the moisture sensor. For installation and servicing,
pinch hoses or power cord beneath dishwasher.
slowly pull the bottom pan from the unit and disconnect the wire
from the moisture sensor, which is located in the center of the pan.
3
3
1
x2
2
Remove front plate.
5
1
2
Attach UL approved 3/4" strain relief (not included) to
bottom of terminal box. Run wires through strain relief.
10
2
3
2
x4
4
Remove factory installed power
cable from terminal block.
6
Black
(Line)
1
1
2
White
(Neutral)
Connect wires to terminal block.
Hardwire Conduit Option
(cont.)
Green
7
(Ground)
3
Connect ground wire. Tighten screws on strain relief.
Note: Reinstall front plate.
11
8
2
3
x4
1
Run wire through grommet on bottom pan.
Replace bottom pan.
Advertisement
Table of Contents
