Leveling; Final Installation - Viking D3 301 Series Installation Manual

Built-in dishwashers
Hide thumbs Also See for D3 301 Series:
Table of Contents

Advertisement

Leveling

7
Equal distance
D O
D O
DOW
N
W N
W N
UP
U P
U P
DOWN
UP
Place a level on handle, then adjust to appropriate
height. Left and right adjust side to side and center
adjusts front to back.
9
x2
Attach screws through bracket into cabinets.
14
8
To check level, front to back, pull the top rack half-way out of
unit. The rack should remain stationary and not move in or out.
Note: Leveling is important for optimal performance.
10
Minimum
20"
(50.8 cm)
from floor
Install High Loop Clip, which is provided, a minimum of
20" (50.8 cm) from the floor. Refer to the Drain section
of "General Information" for proper installation
requirements.

Final Installation

11
1.0"
(2.5 cm)
Cut here for
5/8" (1.6 cm)
Cut here for
3/4" (1.9 cm)
Identify discharge connection size; cut line to correct
size and connect. Clamp if necessary.
12b
(Standard discharge)
Air Gap
12d
(Discharge with food waste disposer and air gap)
15
12a
(Discharge with food waste disposer)
Note: Be sure to remove the knockout or plug from the
fitting of the disposer before connecting drain line.
Air Gap
12c
(Discharge with air gap)
13
Connect water line.

Advertisement

Table of Contents
loading

Table of Contents