Cisco Nexus 3548 Configuration Manual page 127

Configuring Static and Dynamic NAT Translation
Example
This example shows the sample output from the show ip nat statistics command:
switch# show ip nat statistics
IP NAT Statistics
====================================================
Total active translations: 2
No.Static: 2
No.Dyn:
No.ICMP:
----------------------------------------------------
Total expired Translations: 0
SYN timer expired:
FIN-RST timer expired:
Inactive timer expired:
----------------------------------------------------
Total Hits:
In-Out Hits: 0
Out-In Hits: 0
----------------------------------------------------
Total SW Translated Packets: 0
In-Out SW Translated: 0
Out-In SW Translated: 0
----------------------------------------------------
Total SW Dropped Packets: 0
In-Out SW Dropped: 0
Out-In SW Dropped: 0
Address alloc. failure drop:
Port alloc.
Dyn. Translation max limit drop:
ICMP max limit drop:
Allhost max limit drop:
----------------------------------------------------
Total TCP session established: 2
Total TCP session closed:
----------------------------------------------------
NAT Inside Interfaces:
Ethernet1/1
NAT Outside Interfaces: 1
Ethernet1/3
----------------------------------------------------
Inside source list:
++++++++++++++++++++
Access list: ACL1
RefCount: 0
Pool: pool1
Total addresses: 200
Allocated: 0
Missed: 0
0
0
0
0
0
0 Total Misses:
In-Out Misses: 0
Out-In Misses: 3
0
failure drop: 0
0
0
0
1
1
Overload
percentage: 0%
Cisco Nexus 3548 Switch NX-OS Interfaces Configuration Guide, Release 9x
3
Verifying NAT Statistics
117