Default Physical Ethernet Settings - Cisco Nexus 3548 Configuration Manual

Configuring Layer 2 Interfaces
This example shows how to display a brief interface status (some of the output has been removed for brevity):
switch# show interface brief
--------------------------------------------------------------------------------
Ethernet
Interface
--------------------------------------------------------------------------------
Eth1/1
Eth1/2
Eth1/3
Eth1/4
Eth1/5
Eth1/6
Eth1/7
...
This example shows how to display the CDP neighbors:
switch# show cdp neighbors
Capability Codes: R - Router, T - Trans-Bridge, B - Source-Route-Bridge
Device ID
d13-dist-1
n5k(FLC12080012)

Default Physical Ethernet Settings

The following table lists the default settings for all physical Ethernet interfaces:
Parameter
Duplex
Encapsulation
MTU
Port Mode
Speed
1
VLAN Type Mode
200 eth trunk
1 eth trunk
300 eth access down
300 eth access down
300 eth access down
20 eth access down
300 eth access down
S - Switch, H - Host, I - IGMP, r - Repeater,
V - VoIP-Phone, D - Remotely-Managed-Device,
s - Supports-STP-Dispute
Local Intrfce
mgmt0
Eth1/5
Default Setting
Auto (full-duplex)
ARPA
1
1500 bytes
Access
Auto (10000)
MTU cannot be changed per-physical Ethernet interface. You modify MTU by selecting maps of QoS
classes.
Cisco Nexus 3548 Switch NX-OS Interfaces Configuration Guide, Release 9x
Status Reason
up none
up none
SFP not inserted
SFP not inserted
Link not connected
Link not connected
SFP not inserted
Hldtme Capability
148 S I
8 S I s
Default Physical Ethernet Settings
Speed Port
Ch #
10G(D) --
10G(D) --
10G(D) --
10G(D) --
1000(D) --
10G(D) --
10G(D) --
Platform Port ID
WS-C2960-24TC Fas0/9
N5K-C5020P-BA Eth1/5
23