Enabling Vpc Auto-Recovery - Cisco Nexus 3548 Configuration Manual

Configuring Virtual Port Channels
STP Port Type, Edge
BPDUFilter, Edge BPDUGuard
STP MST Simulate PVST
Allowed VLANs
Local suspended VLANs
switch#

Enabling vPC Auto-Recovery

SUMMARY STEPS
1. switch# configure terminal
2. switch(config)# vpc domain domain-id
3. switch(config-vpc-domain)# auto-recovery reload-delay delay
DETAILED STEPS
Command or Action
Step 1 switch# configure terminal
Step 2 switch(config)# vpc domain domain-id
Step 3 switch(config-vpc-domain)# auto-recovery reload-delay
delay
Example
This example shows how to enable the auto-recovery feature in vPC domain 10 and set the delay
period for 240 seconds:
switch(config)# vpc domain 10
switch(config-vpc-domain)# auto-recovery reload-delay 240
Warning:
Enables restoring of vPCs in a peer-detached state after reload, will wait for 240 seconds
(by default) to determine if peer is un-reachable
This example shows how to view the status of the auto-recovery feature in vPC domain 10:
switch(config-vpc-domain)# show running-config vpc
!Command: show running-config vpc
!Time: Tue Dec
feature vpc
vpc domain 10
peer-keepalive destination 10.193.51.170
auto-recovery
1 Normal, Disabled,
Disabled
1 Enabled
- 1,624
- 624
7 02:38:44 2010
Cisco Nexus 3548 Switch NX-OS Interfaces Configuration Guide, Release 9x
Normal, Disabled,
Disabled
Enabled
1
-
Purpose
Enters global configuration mode.
Enters vpc-domain configuration mode for an existing vPC
domain.
Enables the auto-recovery feature and sets the reload delay
period. The default is disabled.
Enabling vPC Auto-Recovery
81