Interface Unit - Furuno CH-300 Installation Manual

2.4

Interface Unit

DATA/VIDEO IN DATA/VIDEO OUT RGB OUT
Transceiver unit cable
06S4078
The blackbox type requires connection of a VGA monitor, via the interface unit
IF-8000. Supply monitor and interconnection cable (Max. length 15 m with
Dsub-15P connectors of male, three rows of 15 pins). The monitor used should
satisfy the specifications shown below.
• VGA type
• ANALOG RGB 0.7 Vpp, positive polarity
• TTL level H, V, Negative polarity
Note 1: Two interface units can be connected to the transceiver unit in parallel.
Note 2: When using DATA/VIDEO OUT port, cut and remove the rubber covers
as below to attach connectors to the interface unit.
Note 3: Connect control unit or navigator equipment to either interface unit or
monitor unit (supplied by FURUNO).
Note 4: When connecting the monitor unit MU-100C to the interface unit, or
two interface units in parallel to the transceiver unit, the length of cables should
be as shown in the figure on next page. Note that two cables 06S4078 (10 m
length) cannot be used.
VGA
monitor
Monitor unit
cable
06S4078
Cut and remove
the covers.
CONT
NMEA
NAV
Earth
Connect to ship's earth.
Control
unit
cable
MJ-A10SPF0002
(1.5/5 m)
Remove the
fixing metals.
2. WIRING
2-7