Interface Unit - Furuno CH-300 Installation Manual

1.5

Interface Unit

The interface unit is shipped with the blackbox type to enable connection of a
monitor. Note that this unit is not necessary when using monitor MU-151C.
1.5.1 General mounting considerations
• The mounting location should be well ventilated and dry. Avoid locations
subject to water splash or rain.
• The unit can be mounted on a bulkhead or the deck.
• The maximum cable length between the interface unit and the transceiver unit
is 10 m. Keep the length in mind when choosing a mounting location.
Transceiver
Transceiver
1.5.2 Mounting method
Fasten the interface unit with four self-tapping screws (5X20, local supplied).
For bulkhead mounting, do as follows:
1. Tighten upper self-tapping screws so there is 5 mm clearance between
bottom of screw head and bulkhead.
2. Hook the transceiver unit on the upper screws.
3. Tighten the upper screws followed by the lower screws.
External
monitor
06S4078
Interface
unit
unit
A
External
monitor
06S4078
Interface
unit unit
A
335
295
315+0.5
06S4078
Monitor unit
A+B 15m
MU-100C
B
External
monitor
06S4078
Interface
unit
C
4- 6
FIXING HOLES
1. MOUNTING
<
=
<
A+C 15m
=
1-27