Furuno CH-300 Installation Manual page 11

1.1.2 Mounting Unibody type
1. Fasten the mounting base to the mounting location with four self-tapping
screws (5X20).
2. Fasten the bracket at the rear of monitor/control unit with four binding screws
(M4x10).
3. Coat threads of upset screws (M6x16, 2 pcs.) used to fasten bracket to
mounting base.
4. Fasten the bracket to the mounting base with two upset screws. (Use the
upper holes to tilt the monitor unit 20°; lower holes to tilt it 9°.)
FRONT
Mounting base
1 2
3
4
Bracket, rear view
Bracket
Upset Screw
Fastening bracket to mounting base
Bracket (rear view)
1 2
3
4
For 9 tilt
Mounting base
For 20 tilt
1. MOUNTING
1-3