Ethernet Connections - Fortinet FortiNac BFN620 Installation Manual

Table 6: Naming Conventions for Appliance BFN630XL
Product Name
NS700CA Ultra High
Performance Control and
Application Server
NS2000C Ultra High
Performance Control Server
NS2000A Ultra High
Performance Application
Server

Ethernet Connections

Each Ethernet port is used for a different purpose during initial configuration and normal
operation. The following table provides details on the options for each appliance type and its
corresponding Ethernet ports.
Note: Manual configuration is required for eth2. The eth3 or fourth interface is reserved for future
use. Contact Customer Support for assistance.
Appliance Product
BFN320 All Products
BFN330
BFN620
BFN630
Appliance Product
All Products
FortiNac Server
FortiNac
Application Server
BFN320
FortiNac Control Server
BFN330
FortiNac Control Manager
BFN620
BFN630
FortiNac Server
FortiNac
Application Server
Appliance
Product Descriptor
Label
NS700CA FortiNac Server
NS2000CA FortiNac
Control Server
FortiNac Application
NS2000CA
Server
Table 7: Ethernet Connections
Port Port Used During Initial (Basic Network) Configuration
eth1 Used temporarily during configuration until the IP address,
mask, default gateway, and host name are setup.
Configuration Wizard DHCP Service—Disabled once
appliance is rebooted (or shutdown and restarted).
Port Port Used During Normal Operations (After Basic
Network Configuration Complete)
eth0 Management
eth1 Isolation networks, such as Registration or Remediation.
eth1 Isolation networks, such as Registration or Remediation.
eth1 Either DHCP detection or not used.
eth1 Not used.
Rogue DHCP detection, additional isolation networks (for
eth2 example, Remote Registration and Remote Scan), access
point management, or not used.
eth2
Additional isolation networks (for example, Remote
Registration and Remote Scan), access point
management, or not used.
Appliance Identifier
SYS-BFN630XL-NS700CA
SYS-BFN630XL-NS2000C
SYS-BFN630XL-NS2000A
3