Layer 2 Network - Configure Vlans - Fortinet FortiNac BFN620 Installation Manual

Layer 2 Network - Configure VLANS

Layer 2 Network - Configure VLANS
The configuration views for the Isolation, Registration, Remediation, Dead End, VPN,
Authentication and VLAN types are similar. The Access Point Management VLAN configuration
view is slightly different in that it contains sections for both authorized and unauthorized clients.
Samples of the Isolation and the Access Point Management views are shown below.
For each VLAN type you are configuring:
Click
1. Next
displayed VLAN type.
2. To configure the VLAN type displayed, select the
such as Isolation or Registration, and enter the required information. See the table
below for definitions of the fields if needed.
3. To Add Subnets, click the
4. Click Next
Table 12: VLAN Isolation Network Field Definitions
Field
VLAN Type Interface eth1
Interface IPv4
Address
Mask
Gateway
VLAN ID
Interface IPv6
Address
Interface IPv6
Mask in CIDR
notation
Interface IPv6
Gateway
Lease Pool
Start
End
Domain
22
to proceed to the next configuration screen if you are not configuring the
Add button in the Isolation DNS Subnets section.
.
Definition
IP4 address for the VLAN interface on eth1. Use a different IP for each VLAN you
configure.
Subnet mask.
Gateway for eth1 when clients connect through this VLAN.
Number used to identify this VLAN throughout the system. This number is used within
FortiNac when modeling switch configurations and when setting up Network Access
VLANS.
IPv6 address for the VLAN interface on eth1. Use a different IP for each VLAN you
configure.
Subnet IPv6 mask for the VLAN interface in CIDR notation format (e.g., 64).
IPv6 Gateway for the VLAN interface for eth1 when clients connect through this VLAN.
Starting and ending IP addresses that delineate the range of IP addresses available on
this VLAN.
check box next to the VLAN type,