Network Type - Fortinet FortiNac BFN620 Installation Manual

Network Type

Network Type
At this point you must indicate whether you are connecting to a Layer 2 or a Layer 3 network.
Important: In a High Availability environment with an L3 configuration where redundant FortiNac
servers are on different subnets and do not use a shared IP address, you must select the Layer 3
network option. L3 High Availability configurations are not supported with Layer 2 Isolation
settings.
• Select the Layer 2 network option to specify VLAN isolation networks and their
corresponding IP addresses. See Layer 2 Network - VLANs on page 21.
• Select the Layer 3 network option to specify routed isolation networks and their
corresponding IP addresses. See Layer 3 Network - Route Scopes on page 28.
Click .
Next
20
Figure 10: Network Type