Dtmf Memory Encoder; I Programming A Dtmf Code - Icom IC-V8000 Instruction Manual

10

DTMF MEMORY ENCODER

I Programming a DTMF code

1
2
DTMF codes are used for autopatching, controlling other
3
equipment, etc. The transceiver has 10 DTMF memory chan-
nels (d0–d9) for storage of often-used DTMF codes of up to
4
24 digits.
5
z Push [FUNC] then [
6
DTMF
DTMF encoder ON.
7
• "d" appears in place of the 100 MHz digit.
8
x Push [
SET
9
ory programming condition.
c Push [Y] or [Z] to select the desired DTMF
10
memory channel.
11
12
[EXAMPLE]: Programming "5428AB453" into DTMF memory channel "d4."
13
14
15
16
17
18
Push
19
20
21
45
6(DTCS)] to turn the
LOW
B(D-OFF)] to enter the DTMF mem-
Push then .
v Push the desired digit keys.
• When the first digit is input, previous memory contents are
cleared automatically.
• "E" stands for "M" and "F" stands for "# ."
• Push [Y]/[Z] and repeat this step if you make a mistake.
• The S/RF indicator shows the digit group. The indication in-
creases every 6 digits.
b Push [VFO/LOCK] to exit the programming condition.
• The [ A(MW)] key cannot be used to exit. If pushed, code "A"
CLR
is input and the previously programmed data is erased. Repro-
gram in such a case.
Push
Push
Push