Setting Procedures - Matsui JL4-5V-3~6 Operation Manual

2. Setting procedure
The codes for each setting item are displayed on the left digital display (red).
The set values are displayed on the right digital display (green).
NOTE
Carry out the respective setting procedures after stopping operation. The setting mode cannot
be turned on during operation .
Step
１
２
３
４
Unless operation is performed for ten seconds or longer, the mode automatically exits the setting mode
and returns to the normal mode.
[WO-4841;JL4-V・VC-3～6-36]
SV
Press the SV switch
The User Setting Mode display flashes.
Codes for setting items and set values are displayed on the digital display.
With this state, respective setting items are sequentially displayed each time when the SV
SV
switch is depressed.
Display code for any desired setting item.
Press the ENTER switch
The set value can now be changed.
Set the set value to any desired value with the UP switch
The set value is written when the ENTER switch
[Remark]
1 setting unit is added every time the UP switch
added when the switch is kept depressed.
1 setting unit is subtracted every time the UP switch
continuously subtracted when the switch is kept depressed.
The mode returns to the normal mode when the SV switch
last setting item (dUP) is displayed.
Chapter 7 Respective Parameter Setup
User setting mode
.
with the code for any desired setting item displayed.
NOTE
- 36 -
or DOWN switch
is depressed.
is depressed. It is continuously
is depressed. It is
SV
is depressed while the
.