Table of Contents
Advertisement
To minimize the effects of negative air pressure:
•
Install optional outside air kit with the intake facing
prevailing winds during the heating season
•
Ensure adequate outdoor air for all combustion
appliances and exhaust equipment
•
Ensure furnace and air conditioning return vents are
not located in the immediate vicinity of the appliance
•
Avoid installing the appliance near doors, walkways or
small isolated spaces
•
Recessed lighting should be a "sealed can" design
•
Attic hatches weather stripped or sealed
•
Attic mounted duct work and air handler joints and
seams taped or sealed
•
Basement installations should be avoided
WARNING
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
•
Installation and use of any damaged appliance.
•
Modification of the appliance.
•
Installation other than as instructed by Hearth &
Home Technologies.
•
Installation and/or use of any component part not
approved by Hearth & Home Technologies.
•
Operating appliance without fully assembling all
components.
•
Operating appliance without legs attached (if
supplied with appliance).
•
Do NOT Over fire - If appliance or chimney
connector glows, you are over firing.
Any such action that may cause a fire hazard.
D. Tools And Supplies Needed
Before beginning the installation be sure the following tools
and building supplies are available:
Reciprocating saw
Pliers
Hammer
Phillips screwdriver
Flat blade screwdriver
Plumb line
Level
Misc. screws and nails
1/2-3/4 in. length, #6 or #8 self-drilling screws
17 August, 2018
Framing material
High temp caulking material
Gloves
Framing square
Electric drill and bits
Safety glasses
Tape measure
7/16 socket or wrench
E. Inspection of Appliance and Components
•
Remove appliance and components from packaging
and inspect for damage.
•
Report to your dealer any parts damaged in shipment.
•
Read all the instructions before starting the installation.
Follow these instructions carefully during the installation
to ensure maximum safety and benefit.
F. Removal of Appliance from Shipping
Materials
1. Remove box and 51mm x 102mm structural boards
being careful not to damage product.
2. Using 7/16 socket or wrench remove one bolt located
inside front part of appliance (Figure 5.1).
3. Moving to the back of the appliance and using 7/16
socket or wrench remove two bolts (Figure 5.1).
4. Carefully pull appliance off of pallet and put in desired
location following Hearth Pad and Clearance to
Combustibles on pages 8 and 9.
Figure 5.1
Fire Risk.
Inspect appliance and components for damage.
Damaged parts may impair safe operation.
•
Do NOT install damaged components.
•
Do NOT install incomplete components.
•
Do NOT install substitute components.
Report damaged parts to dealer.
7075-177A
VOYAGEUR GRAND AU
WARNING
3
5
Advertisement
Table of Contents
