Quadra-Fire GRAND-MBK-AU Installation Manual page 23

4. Remove the 2 screws at the top of the control plate.
Push the bottom of the control plate to the inside of
the appliance and partially remove the control plate
assembly.
5. Locate the black and white wires that are part of the
power cord and disconnect those wires from the wire
harness.
Remove Screw
6. Remove the screw that is holding the ground lug to the
control plate.
17 August, 2018
White Wire
Black Wire
Green Grounding
Wire
7. Use needle nose pliers to remove the strain relief that
protects the power cord from the control plate.
8. The power cord is now disconnected from the blower
control plate. Pull the cord out through the right side of
the appliance.
Route Cord Through
Retainer Clip
9. Insert the power cord through the left side of the
appliance in the hole contains the grommet. Pull the
connection ends to the right side. Route the power cord
through the retainer clip.
7075-177A
VOYAGEUR GRAND AU
Grommet
23