Table of Contents
Advertisement
To minimize the effects of negative air pressure:
• Install optional outside air kit with the intake facing
prevailing winds during the heating season
• Ensure adequate outdoor air for all combustion
appliances and exhaust equipment
• Ensure furnace and air conditioning return vents are not
located in the immediate vicinity of the appliance
• Avoid installing the appliance near doors, walkways or
small isolated spaces
• Recessed lighting should be a "sealed can" design
• Attic hatches weather stripped or sealed
• Attic mounted duct work and air handler joints and seams
taped or sealed
• Basement installations should be avoided
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• Installation and use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
• Operating appliance without fully assembling
all components.
• Operating appliance without legs attached (if supplied
with appliance).
• Do NOT Over fire - If appliance or chimney connector
glows, you are over firing.
Any such action that may cause a fire hazard.
D. Tools And Supplies Needed
Before beginning the installation be sure the following tools
and building supplies are available:
- Reciprocating saw
- Pliers
- Hammer
- Phillips screwdriver
- Flat blade screwdriver
- Plumb line
- Level
- Misc. screws and nails
- Framing material
- High temp caulking material
- Gloves
- Framing square
- Electric drill and bits
- Safety glasses
- Tape measure
- 7/16 socket or wrench
- 1/2-3/4 in. length, #6 or #8 self-drilling screws
5
WARNING
E. Inspection of Appliance and Components
•
Remove appliance and components from packaging
and inspect for damage.
•
Report to your dealer any parts damaged in shipment.
•
Read all the instructions before starting the installation.
Follow these instructions carefully during the installation
to ensure maximum safety and benefit.
F. Removal of Appliance from Shipping Materials
Step Top:
1. Remove box and 2x4 structural boards being careful
not to damage product.
2. Using 7/16 inch socket or wrench, remove and discard
the two lag bolts from mounting brackets; one on
each side, that is attaching the appliance to the pallet
(Figure 5.1).
3. Carefully pull appliance off of pallet and lay appliance
on back side on a protective surface.
4. Reference Appliance Set-Up for ash removal system,
leg or pedestal attachment options.
5. After appliance is completely assembled place in
desired location following Hearth Pad and Clearance
to Combustibles on page
Figure 5.1
Fire Risk.
Inspect appliance and components for
damage. Damaged parts may impair
safe operation.
• Do NOT install damaged components.
• Do NOT install incomplete components.
• Do NOT install substitute components.
Report damaged parts to dealer.
7037-806A
11.
Lag bolt
Lag bolt
Mounting
bracket
WARNING
05/21
Advertisement
Table of Contents
