Table of Contents
Advertisement
VOYAGEUR GRAND AU
E. Securing Appliance to Stove Pipe/Liner
1. Once you have the appliance in place and secured,
reach up through the flue opening and grab the
attachment bar and pull down inside flue opening
(Figure 20.1).
2. Insert the 5/16 bolts inside the cast flue and through
the chimney mounting bar. Securely tighten the nuts.
Fasteners are provided.
3. Re-install the tube channel assembly, baffle board,
ceramic blanket and baffle protection channel.
Attachment
Bar
Figure 20.1
20
5/16 Bolts
5/16 Nuts
F. Surround & Trim Kit Installation
Standard Size: 109.22cm W x 78.74cm H
Large Size: 129.54cm W x 86.36cm H
1. Lay surround face down on a protected surface to
prevent scratching.
2. Using a 4 to 6 inches long Phillips head screw driver
attach the side surrounds to the top surround using (2)
#8 sheet metal screws on each side provided with the
kit (Figure 20.3).
3. Lay the trim face down and place the corner brackets
into position.
4. Using a standard flat screw driver tighten the corner
brackets (Figure 20.3).
5. Slide the assembled trim set over the surround set. and
then over the appliance matching the mounting tabs on
the side pieces with the slots on the appliance (Figure
20.3).
6. Align the 2 screws in the top surround piece to the 2
alignment holes on the appliance top. Secure in place
(Figure 20.2).
7. Use the strain relief in the surround side for blower cord
installation and use the cover plug to insert into the
hole where the blower cord is not installed.
Secure to
Firebox Face
Mounting Tabs
Slide into Slots
on Firebox Face
Figure 20.2
Figure 20.3
7075-177A
Strain Relief for
Blower Cord and
Cover Plug for hole
in each side
Corner Brackets
17 August, 2018
Advertisement
Table of Contents
