Changing The Size Of The Paper In The Paper Tray - Samsung SCX-6545N Series User Manual

MEDIA TYPE
• To avoid damaging the machine, use only
Transparencies
transparencies designed for use in laser printers.
• Transparencies used in the machine must be able
to withstand 180 °C, the machine's fusing
temperature.
• Place them on a flat surface after removing them
from the machine.
• Do not leave them in the paper tray for long periods
of time. Dust and dirt may accumulate on them,
resulting in spotty printing.
• To avoid smudging caused by fingerprints, handle
them carefully.
• To avoid fading, do not expose printed
transparencies to prolonged sunlight.
• Ensure that transparencies are not wrinkled, curled,
or have any torn edges.
• To avoid damaging the machine, use only labels
Labels
designed for use in laser machines.
- When selecting labels, consider the following fac-
tors:
- Adhesives: The adhesive material should be sta-
ble at your machine's fusing temperature. Check
your machine's specification to view the fusing
temperature, see page 126.
- Arrangement: Only use labels with no exposed
backing between them. Labels can peel off sheets
that have spaces between the labels, causing
serious jams.
- Curl: Prior to printing, labels must lie flat with no
more than 13 mm of curl in any direction.
- Condition: Do not use labels with wrinkles, bub-
bles, or other indications of separation.
• Make sure that there is no exposed adhesive
material between labels. Exposed areas can cause
labels to peel off during printing, which can cause
paper jams. Exposed adhesive can also cause
damage to machine components.
• Do not run a sheet of labels through the machine
more than once. The adhesive backing is designed
for only a single pass through the machine.
• Do not use labels that are separating from the
backing sheet or are wrinkled, bubbled, or otherwise
damaged.
• Do not print on media smaller than 98 mm wide or
Card stock or
356 mm long.
custom-sized
• In the software application, set margins at least
materials
6.4 mm away from the edges of the material.
37 _Loading originals and print media
GUIDELINES MEDIA TYPE
• Letterhead must be printed with heat-resistant ink
Preprinted
that will not melt, vaporize, or release hazardous
paper
emissions when subjected to the printer's fusing
temperature for 0.1 second. Check your machine's
specification to view the fusing temperature, see
page 126.
• Letterhead ink must be non-flammable and should
not adversely affect printer rollers.
• Forms and letterhead should be sealed in a
moisture-proof wrapping to prevent changes during
storage.
• Before you load preprinted paper, such as forms
and letterhead, verify that the ink on the paper is
dry. During the fusing process, wet ink can come off
preprinted paper, reducing print quality.
CHANGING THE SIZE OF THE PAPER IN THE
PAPER TRAY
To load longer sizes of paper, such as Legal-sized paper, you need to
adjust the paper guides to extend the paper tray.
If you have installed an optional high capacity feeder, refer to Quick
Install Sheet to adjust paper size.
1. Adjust the paper length guide to the desired paper length. It is preset
to Letter or A4 size depending on the country. To load another size,
hold the lever and move the length guide to the corresponding
position.
GUIDELINES
1 paper length guide
2 paper width guide