Understanding Display Messages - Samsung SCX-6545N Series User Manual

3. Remove the jammed paper.
4. Pull up on the stacker lever and then close the stacker front cover.
Paper jam at exit of finisher
1. Gently pull the paper out through the exit area.

UNDERSTANDING DISPLAY MESSAGES

Messages appear on the Smart Panel program window or on the control
panel display to indicate machine status or errors. Refer to the tables below
to understand the messages meaning to correct the problem, if necessary.
Messages and their explanations are listed in alphabetical order.
• If the message is not in the table, cycle the power and try the
printing job again. If the problem persists, call for service.
• When you call for service, it is very convenient to provide the
service representative with the contents of display message.
• Some messages may not appear in the display depending on
options or models.
• [yyy] indicates the part of the machine.
• [zzz] indicates the error code. When you contact the service
center, this error code help to handle the problem.
• You may see an exclamation mark (
the upper left of the display, in that case, press the question mark
to browse detailed information on the supplies.
.
MESSAGE MEANING
The life of the part
[yyy] is worn.
expires totally.
Replace with new
one
There is a problem in
DC motor does not
the control of DC
operate: [zzz].
motor unit.
Please turn off then
on
Not supplied toner to
Did not supply
the imaging unit.
enough toner.
Remove seal tape &
reinstall
The machine received
Did not supply
several papers with
enough toner.
many images, and it
Please open/close
cannot supply the
door
toner properly.
There is no more
Fax memory is
available fax memory.
almost full. Print or
No more fax data can
remove received fax
be received.
Job
Available fax memory
Fax memory is full.
is now 1MB.
Print or remove
received fax Job
The finisher cover is
Finisher door is
not securely latched.
open. Close it
) or a cross mark ( ) on
SUGGESTED
SOLUTIONS
Replace the part with a
new one. Call for
service.
Turn the machine off
and turn it on again. If
the problem persists,
please call for service.
• Remove the sealing
tape from the
imaging unit.
• Thoroughly roll the
toner cartridge five or
six times, and
reinstall it.
• Turn the machine off
and turn it on again.
Open side door and
close it. If the problem
still persists, please call
for service.
Delete the received fax
data in the memory to
secure memory. Call
for service.
Delete the received fax
data in the memory to
secure memory. Call
for service.
Close the finisher until it
locks into place.
Troubleshooting_ 108