Transducer Cable; Hsb Series L755 And L760 Fishfinder - Raytheon HSB L760 Owner's Handbook Manual

2-14

Transducer Cable

CAUTION:
Do not cut the transducer cable or remove the connector. Do not try to
shorten or splice the cable. If the cable is cut, it cannot be repaired.
Cutting the cable will also void the warranty.
A 30 ft (10m) cable, with connector attached, is supplied with the transducer.
The connector has a removable nut to aid installation. To allow you to
complete the installation without cutting the cable, ensure that any holes you
drill are large enough to accept the connector, with the nut removed.
• For a Transom mount installation – route the cable up and over the top edge
of the transom as shown in Figure 2-9. Secure the cable using cable clamps
(available from your local marine equipment supplier).
If you do not want to expose the cable on deck, you may drill a hole 3/4"
(19 mm) through the transom for the cable (with connector attached). To
seal the opening, use a feed-thru cap where the cable passes through the
transom.
• For either type of installation – run the cable through the interior of the
boat, referring to EMC Installation Guidelines on page 2-3.
• If the 30 ft (10 m) cable is not long enough, extension cables are available
from your Raytheon dealer. When you attach the extension cable, be sure
that the connections are watertight. Use Dow Corning DC-4 or an equiva-
lent sealing compound to protect the connector assemblies.
Figure 2-9: Installing the Cable on a transom Mount Transducer

HSB Series L755 and L760 Fishfinder

Cable cover
Cable clamps
2 in (50 mm)
Double sided tape
and sensor
D5033-1