Changing The Set Up Parameters - Raytheon HSB L760 Owner's Handbook Manual

7-2

7.2 Changing the Set Up Parameters

The set up parameters are divided into three sections:
• System, to control the aspects of the system that are not specific to the fish-
finder or chart.
• Fishfinder, to control the fishfinder display preferences, including HSB
mode, calibration and simulator.
• Chart, to control the chartplotter display, including waypoint information,
vectors and radar/chart synchronization.
Note: The GPS menu is described in Chapter 6 and the Track Set Up menu is
described in Chapter 5.
This section provides instructions for displaying and changing the default
values. The following sections list the parameters and their possible settings,
and describe the function of each parameter in turn.
➤ To set the default parameters:
1. Press the MENU key to display the set up soft keys. The options available
MENU
depend on the selected operating mode.
Fishfinder
Chart
2. Press the soft key for the set up you require.
The requested set up menu is displayed, listing the parameters and their
current settings.
3. Use the trackpad to move the selection bar up and down the list. An arrow
is displayed at the top or bottom right-hand corner if you can scroll the list
to display further parameters.
As each line is highlighted, the soft keys are updated to show the settings
available.
• For parameters that have a numeric value, or more than four possible
• Some parameters are controlled by a slider that is displayed above two
SYSTEM SONAR
SET UP¬ SET UP¬
SYSTEM CHART
SET UP! SET UP!
settings, a scroll list is displayed above two of the soft keys.
of the soft keys.
HSB Series L755 and L760 Fishfinder
SCROLL TRIP
SPEED RESET
D5019-1
TRACK GPS
SET UP! SETUP!
D4162-1